Specifications

Safety
TX,05,DH1729 –19–26JAN91–1/1
USE SAFETY LIGHTS AND DEVICES
N36564 –UN–10FEB89
A—Lights
B—Slow Moving Vehicle Emblem
C—Reflector Tape
D—Reflectors
Operators of machines that travel below normal highway
speeds should take special precautions to avoid collision
with other vehicles.
Before driving on public roads, check state and local laws
that may apply to tractors, self-propelled machines, and
towed equipment. Additional lights, mirrors, SMV
emblems, or reflectors may be required.
Install and use all safety lights and devices necessary to
assure safe operation and local compliance. Keep these
safety items in good condition. Replace missing or
damaged parts immediately.
TX,05,DH1846 –19–14MAY91–1/1
KEEP ROPS INSTALLED PROPERLY
A damaged roll-over protective structure (ROPS) should
be replaced, not reused.
The protection offered by ROPS will be impaired if ROPS
is subjected to structural damage, is involved in an
overturn incident, or is in any way altered by welding,
bending, drilling, or cutting.
If ROPS was loosened or removed for any reason, inspect
it carefully before operating the machine again.
To maintain the ROPS:
• Replace missing hardware using correct grade
hardware.
• Check hardware torque.
• Check isolation mounts for damage, looseness or
wear; replace them if necessary.
• Check ROPS for cracks or physical damage.
05–14
PN=14