Specifications

Troubleshooting
TX,100,DH2482 –19–02OCT92–2/8
Symptom Problem
Solution
Starting Motor Turns, But Engine Starter pinion not engaging flywheel See your authorized dealer.
Will Not Crank ring gear.
Starter pinion or flywheel gear teeth See your authorized dealer.
broken.
Starting Motor Continues To Run Starter solenoid stuck. See your authorized dealer.
After Engine Starts
Starter not disengaging. See your authorized dealer.
Starter relay stuck. See your authorized dealer.
Key switch. See your authorized dealer.
Wiring harness shorted. See your authorized dealer.
Battery Using Too Much Water Battery being overcharged. See your authorized dealer.
High ambient temperature. Refill with distilled water.
Cracked battery case. Replace battery. Install hold down
correctly.
Low Battery Output Low water level. (See "Battery Using Too Much
Water" and "Cracked Battery Case"
in this group.)
Dirty or wet battery top, causing Clean battery and wipe dry.
discharge.
Corroded or loose battery cable Clean and tighten cable end clamps.
ends. Recharge battery. If unit has two
batteries, recharge separately.
Broken or loose battery posts. Move posts by hand. If posts are
loose or will turn, replace battery. If
unit has two batteries, replace both
batteries.
Loose fan/alternator belt, or worn Inspect belt or pulley. Adjust or
pulleys. replace as necessary.
Continued on next page
100–15
PN=257