Specifications

Storage
TX,105,FF,400 –19–06SEP94–2/2
T6181AU –UN–18OCT88
IMPORTANT: Prevent possible engine damage.
During cold temperatures, check
fluidity of engine oil on dipstick. If the
oil appears waxy and/or jelly-like rather
than liquid, DO NOT attempt to start
engine. Use external heat source to
warm the crankcase until oil appears
fluid.
3. Check all fluid levels. If low, check for leaks and
add oil as required.
4. Check belts.
5. Check condition of all hoses and connections.
6. Check electrolyte level. Charge and install battery.
7. Fill fuel tank.
8. Pre-lubricate turbocharger bearings:
a. Remove engine shut-off fuse.
b. Crank engine for 10 seconds.
c. Install engine shut-off fuse.
d. Start engine. Run several minutes at 1/3 speed
until engine is at normal operating temperature.
9. Bleed fuel system. If engine fails to start or runs
poorly after starting, change fuel filter(s). Bleed fuel
system again.
10. Operate all controls, levers, seat adjustments, etc.
11. Cycle all hydraulic functions several times. Check
condition of all hoses and connections.
12. Check condition of tires. Check tire pressure.
105–3
PN=286