Specifications

Operating the Engine
TX,25,JC1155 –19–03JUN96–2/2
T7747BT –UN–19MAY92T7527EF –UN–01AUG91
IMPORTANT: Excess starting fluid could damage
engine; press starting aid button only
when engine is cold and cranking.
Starting aid fluid is being injected into
engine as long as you press button.
2. After one or two revolutions of engine crankshaft, press
starting aid button (A) at short intervals. Crank engine
for 20 seconds maximum, then allow 2 minutes
between cranking periods.
REPLACING STARTING AID CAN
1. Turn container (B) counterclockwise to remove the
container and starting aid can.
2. Remove safety cap and spray button from new can.
3. Place new can in container.
4. Turn container clockwise in starting aid base (C) to
install starting aid can.
OPERATING MACHINE WITHOUT STARTING AID CAN
INSTALLED
IMPORTANT: Protect starting aid components from
possible damage. Install the starting
aid can container upside down.
Remove container from base, turn upside down, and
reinstall.
T82,25,C53 –19–03DEC91–1/1
USING COOLANT HEATER—IF EQUIPPED
Ö
CAUTION: Prevent possible injury from fire
from an overheated electrical cord. Use a
heavy-duty, grounded cord to connect heater to
electrical power.
Connect the coolant heater to 115-volt electrical power 10
hours before you start the engine.
25–5
PN=59