1 2 IN THE BOX 1. U ltraGold MC Cartridge with Stylus Guard 3 2. Stylus Cleaning Brush 5 3. Philips Driver 4. 2.5mm x 8mm Philips Screw (2) 5. 2.
SETUP 1 White Red Green Black Philips Screws 2 Washers Keep stylus guard in place during installation to prevent damage to the needle 1. C onnect the four headshell leads, making sure the color-coated leads match the corresponding colorcoded pins. 2. C arefully mount cartridge to the headshell. Using the threaded screw holes in the metal body as guides, gently tighten the screws while leaving enough tolerance to make slight adjustments.
3. C arefully remove stylus guard, balanced the arm, and set an approximate tracking force of 2g. 4. U sing the Mobile Fidelity GEO-Disc or other alignment tool, set overhang/zenith by adjusting cartridge so the stylus tip sits right on the bullseye while the cantilever is parallel with the line that intersects the bullseye. Then tighten the cartridge screws and double-check your work. 3 4 Center Line I f your turntable allows, check VTA, azimuth, and anti-skate. Double-check overhang/ zenith.
USAGE AND CARE Always use tonearm’s lift mechanism for cueing Back to Front Clean your records before each play to avoid unnecessary wear After each play, gently clean your stylus, always brushing back-to-front. We recommended Mobile Fidelity LP#9 Stylus Cleaner.
UltraGold MC Type Dual Moving Coil Stereo Weight 7.3g Tracking Force 1.8–2.2g Recommended Load ≥ 100 Ohm Static Compliance 40 x 10e-6/dyne Dynamic Compliance 10 x 10e-6/dyne Frequency Response 20–35,000Hz Stylus Shibata Output Voltage 0.
www.mofielectronics.
