1 IN THE BOX 1. U ltraPhono™ Phono Preamp/ Headphone Amplifier 2.
Indicator Light INSTALLATION Mono/ Stereo Selector Subsonic Filter Headphone Jack Headphone Volume Knob/ Mute Button Check all connections before you plug in the power supply UltraPhono™ will operate at its best when properly installed in a location that’s free from magnetic fields like those generated by equipment with power transformers (such as an amplifier), and within a reasonable distance between your turntable and audio component(s).
Input Right (Red) Once you’ve placed UltraPhono™ in a suitable area, connect your turntable’s interconnects and ground wire (if supplied) to the phono preamp’s inputs, matching each connector to the inputs as shown. Attach another set of interconnects from the phono preamp’s outputs to the line-level analog inputs of your amplifier or preamplifier/processor. Plug in the provided power supply between the phono preamp’s power input and a wall outlet or line conditioner.
On 1 2 3 4 5 6 7 8 9 10 11 12 DIP Switches Located on Underside Off CARTRIDGE LOADING UltraPhono™ has been engineered to work with a wide array of phono cartridges on the market today. Because phono cartridges require special impedance and gain settings, you should configure UltraPhono™ to suit the cartridge of your choice. Out of the box, UltraPhono™ is factory set to operate with most high-output Moving Magnet (MM), Moving Coil (MC), or Moving Iron (MI) phono cartridges.
Locate the DIP switches, which are found on the underside. Each switch is arranged in a mirror pattern for left and right channels. Start by selecting each DIP switch for the recommended impedance of your cartridge as shown in the Input Impedance Settings chart. Next, select the best gain setting for your cartridge using the Cartridge Output Settings chart and set DIP switches accordingly. For Moving Magnet (MM), start with 40dB. For Moving Coil (MC), start with 60dB.
OPERATION Once you have connected cables between UltraPhono™ and your turntable and amplifier/ preamplifier, and completed the setup of your impedance and gain settings, plug in the power supply.
StudioPhono™ UltraPhono™ Gain Adjustable from 40dB - 66dB Adjustable from 40dB - 66dB THD < .01% (MM) / < .012% (MC) < .006% (MM) / < .055% (MC) Load Impedance (MM) 47,000 Ohms 47,000 Ohms Load Impedance (MC) 75, 100, 500, 1k, 10k, 47k Ohms 75, 100, 500, 1k, 10k, 47k Ohms Headphone Output – 8V RMS Max, 62 Ohms, 1.
www.mofielectronics.
