Clic Enhanced Resilient Tile UNICLIC® INSTALLATION Clic Step—Urban Patina Living Local 160 South Industrial Blvd. Calhoun, GA. 30701 MohawkGroup.com Technical Services Department 508 East Morris St. Dalton, GA 30721 800.833.6954 product_tech@mohawkind.com © 2017 Mohawk Group | mohawkgroup.
Clic ERT | U N I C L I C ® I N S T A L L A T I O N General Guidelines ‘Clic’ Enhanced Resilient Tile (ERT) is constructed with the patented Uniclic® tongue and groove design that locks the planks together to form a tight and durable joint that limits moisture from passing through the seams. ‘Clic’ ERT is installed as a floating floor and adhering product to the substrate is not recommended. Not recommended for wet areas or bathrooms. WARRANTY NOTE: Exclusions apply with respect to rolling loads.
Clic ERT | U N I C L I C ® I N S T A L L A T I O N • Un-opened cartons of flooring should be stored flat and neatly stacked in the climate controlled installation area for a minimum of 48 hours prior to installation to allow product to acclimate. Open cartons just prior to installation. • When installing flooring from two or more cartons, check the pattern, color and run (lot) numbers on the carton label to ensure they are all the same.
Clic ERT | U N I C L I C ® I N S T A L L A T I O N • Any wood and wood composition panels should be APA rated and approved, and intended for subfloor use, providing they are smooth, flat, structurally sound and free of deflection. NOTE: If the subfloor has excessive vertical movement (deflection) before installation of the flooring, it is likely it will do so after installation of the flooring is complete.
Clic ERT | U N I C L I C ® I N S T A L L A T I O N Installation 1. Snap a chalk line for your first row to follow. 2. Determine if the starter row will need to be cut. If the first row of planks does not need to be trimmed in width, proceed. Perimeter planks should not be less than 1/2 the width of the plank. 3. Identify tongue/short side of plank. Tongue side should start facing the wall if working left to right.
Clic ERT | U N I C L I C ® I N S T A L L A T I O N Additional Instructions/Notes IMPORTANT: Maintain a ¼” expansion space around all walls, cabinets, pipes, toilet flanges and any immoveable object in the floor. Baseboard molding will cover this expansion space. • For plank installation, we recommend staggering the end joints a minimum of 6 inches. • For tile installation, we recommend staggering the end joints a minimum of 3 inches.
Clic ERT | U N I C L I C ® I N S T A L L A T I O N 5. Cut several pieces of acrylic double face tape made for vinyl floors and slide under the edges of the existing floor on the two edges where the replacement plank/tile will have its lips cut off. Tape should face sticky side up; leave the paper on the side facing down on the floor. 6.
