Installation Sheet

Page 7 / 7

Clic ERT | UNICLIC® INSTALLATION

5. Cut several pieces of acrylic double face tape made for vinyl oors and slide under the edges of the existing oor on the

two edges where the replacement plank/tile will have its lips cut off. Tape should face sticky side up; leave the paper on

the side facing down on the oor.

6. Using water resistant PVA (polyvinyl acetate) glue, run a small bead on the groove edge of the planks/tiles on the

existing oor where the replacement plank/tile will rest that has the lips cut off.

NOTE: The long tongue of the replacement plank/tile and the uncut compression t end joint will not need tape or seam

adhesive as you will be using the plank’s/tile’s locking mechanism.

7. Install replacement plank/tile by sliding the long groove of the replacement plank/tile under the tongue of the oor

plank/tile until the nish edge of the replacement plank/tile is tight against the nish edge of the oor plank/tile, and the

compression end joint is lined up. Rotate down, locking the long tongue joint and roll the compression end joint to lock

into place with a small or hand roller.

8. Wipe any excess sealer that comes to the surface of the tiles with a damp cloth and follow with a dry cloth to assure all

sealer is removed from tile surface.

9. Keep foot trafc off the replaced plank/tile for 24 hours.

NOTE: Mohawk Group will not be held responsible for problems that may arise from use of alternative seam sealers. Please contact

the seam sealer’s manufacturer with issues

We continuously make technological advancements that improve product performance or installation techniques and methods.

To conrm you have the most recent installation instructions, please visit our website at www.mohawkgroup.com or contact

Technical Services at 800.833.6954.