Installation

Page 6 / 8

Glue Down Commercial Resilient Tile | INSTALLATION

Mohawk Adhesives

Use of Mohawk adhesives is required for warranty to apply.

Mohawk M700

Acrylic adhesive with extremely aggressive tack, formulated to provide high shear and peel strength for installing Mohawk

commercial resilient tile and resilient plank. M700 forms a secure plasticizer and moisture-resistant bond. This high solids

adhesive is also non-staining and contains MicroSept antimicrobial system for enhanced resistance to mold and mildew. May

be installed on concrete that is above, on and below grade, APA approved plywood, and underlayment-grade hardboard.

Testing Requirements: Slabs up to 90% RH and 10 pH or less.

Mohawk M95.0

Premium high strength adhesive for installing resilient sheet, tiles and dimensionally stable resilient plank over porous

and non-porous substrates. Mohawk M95.0 is a solvent free, water-based acrylic adhesive suggested for use in occupied

buildings, as it is low in odor, and contains “zero” (calculated) VOC’s.

Testing Requirements: Slabs up to 95% RH and 10 pH or less.

Mohawk MS160

MS160 Spray Adhesive is a water-based adhesive recommended for installations of resilient oor coverings. It is particularly

convenient for use in occupied buildings and greatly reduces the handling and application requirements associated with

conventional adhesives. Normal trafc is allowed as soon as the installation is complete. Mohawk MS160 Adhesive

demonstrates highly aggressive grab and shear strength, and has outstanding water and plasticizer resistance.

Testing Requirements: Slabs up to 95% RH and 11 pH or less.

Adhesive Application

Use of Mohawk adhesives is required for warranty to apply.

• For full spread application, use Mohawk M700 or M95.0 Adhesives with a 1/32” x 1/16” x 1/32” U-Notch trowel. Follow

the directions on the adhesive label.

• For spray adhesive application, use Mohawk MS160 Spray Adhesive. Follow the directions on the adhesive label.

• After placing the material into the adhesive, roll in both directions with a minimum 75-100 lb. 3-section roller.

Tools And Materials Needed

• Mohawk M700 or M95.0 Resilient Flooring Adhesive or Mohawk MS160 Spray Adhesive.

• Trowel Sizes: 1/32” x 1/16” x 1/32” U-Notch for M700 and M95.0 (spread rate: 175 - 225 sq. ft./gallon). Trowel not

required with MS160 (spread rate: 150 sq. ft./can).

Note: This adhesive spread rate is appropriate over most smooth substrates to achieve adequate transfer.

• 75-100 lb. 3-section Roller

• Chalk Line

• Carpenter Square