Installation Instructions

NOTE: Any concrete floor, even when adequately cured and dry, can

allow moisture vapor to pass through to its surface. Depending upon

the type of carpet and method of installation, the moisture emission

rate greatly influences the long-term success of an installation. The use

of a properly installed, uncompromised, approved moisture membrane

is essential in preventing moisture migration into and through a

concrete slab. (Ref. ASTM F 710)

8.1.1 Moisture Mitigation

Concrete that has been treated with a moisture mitigation system will render

the substrate non-porous. Before installation, a bond test is recommended. If

the bond test fails, the substrate must be adequately prepared to accept

adhesive.

8.2 Wood

Wood substrates are required to be structurally sound, flat, dry and securely

anchored. Substrates, such as plywood, hardwood, particleboard, oriented strand

board, or other materials, are required to be flooring grade (APA approved) and

installed according to manufacturer specifications. Irregularities, imperfections

and joints are required to be properly patched and prepared. The use of a primer

on the substrate will improve bond strength of the patch (refer to Section 8.9).

8.2.1 Treated Wood

Wood that is chemically treated to alter properties relating to outdoor exposure

or flame resistance is not a suitable substrate for direct glue-down applications.

Floor covering adhesives may be subject to chemical degradation when applied

to these surfaces.

8.3 Metal

It is required that metal floors create a smooth, even plane, and be free of grease,

oil, soil, and rust.

8.4 Resilient

Installing carpet over resilient flooring may be acceptable as long as the resilient

flooring is securely bonded to the substrate and all waxes, sealers, floor finishes

and other foreign materials have been removed. It is not recommended to install

over floating, perimeter bonded or cushion-backed sheet goods.