Installation Instructions

15
Painted surfaces may be suitable for adhesive application; however, bond tests are
recommended. Glossy surfaces must be abraded prior to installation. Contact the
adhesive manufacturer for requirements.
8.9 Primers
Using primers on floor surfaces generally is not required except for sanded wood
sheet products and dusty, porous or acoustical concrete surfaces. Primers are not
designed to reduce moisture vapor emissions and should not be used for that
purpose. They should be compatible with adhesives, which can only be applied
after the primer is cured. Where lightweight or acoustical concrete substrate is
present, refer to manufacturer requirements for the proper installation procedure
to use before the carpet is installed.
NOTE: Substrate primers are recommended by some manufacturers
for specific carpet installations to enhance adhesion.
8.10 Chemical Adhesive Removers and Abatement Chemicals
These products are not recommended for use on a substrate that will receive a floor
covering.
8.11 Sweeping Compounds
Do not use sweeping compounds prior to adhesive application. The residue from
these compounds interferes with adhesive bonding. In lieu of using sweeping
compounds, vacuum dusty areas instead. Vacuum cleaners are required to have a
properly functioning filter per OSHA and/or EPA requirements.
9.0 Product Acclimation
It is recommended that carpet and installation materials be allowed to acclimate in
the installation area for a minimum of 24 hours at a temperature of 65-95ºF (18 -
35ºC). Carpet must be adequately protected from soil, dust, moisture and other
contaminants. Follow manufacturer’s instructions for acclimation.