Installation Instructions

NOTE: Size and shape of the room will determine corner designation. Red

arrows denote use of a power stretcher and blue arrows denote use of a knee

kicker.

Step 1: Hook onto tack strip approx. 3 ft. in both directions along corner A.

Step 2: Power stretch at approx. 15° angle from wall AC and hook onto tack

strips at corner B.

Step 3: Hook & secure onto tack strip with knee kicker along wall from A to B.

Step 4: Power stretch at approx. 15° angle from wall AB and hook onto tack

strip at corner C.

Step 5: Hook & secure onto tack strip with knee kicker along wall from A to C.

Step 6: Power stretch at approx. 15° angle from wall AB and hook along wall

from C to D.

Step 7: Power stretch from wall AC and hook along wall from B to D.

The use of a Power Stretcher is MANDATORY. Devices used as a substitute for, or an

attachment to such devices that penetrate through the carpet backing may cause injury,

damage carpet or substrates, or result in inadequate stretch. Such devices are not

acceptable.

Power Stretcher – This tool should have all of the following:

 Based on the carpet construction, the proper head should be selected for the

power stretcher:

 pins – recommended for cut pile

 cotton head – recommended for loop construction

 Ability to lock the stretch in place.

 Adjustable metal tubes ending in a padded tail block/plate.

NOTE: Failure to power stretch may result in:

 wrinkling and buckling

 damage to the carpet

 delamination of secondary backing

11.5 Amount of Stretch

Due to the difference in carpet backing types, it is required that manufacturer

instructions for carpet stretch be followed. In the absence of specific instructions,

tufted carpet with synthetic backing should be stretched a minimum of 1% in length

and in width. Patterned carpet may require additional stretch to obtain pattern

match.