Installation Instructions

24
Restrict carpet exposure to water from cleaning or other sources for a
minimum of 30 days.
12.7.2 Materials for Protection
It is recommended that carpet installation be the last trade on any job site.
However, if it is required to protect the finished floor covering from soil or
paint, or if additional work is required to be done after the installation, the
carpet should be covered with a non-staining, breathable building material
paper. Protect the installation from rolling traffic by using sheets of hardboard
or plywood in potentially affected areas.
NOTE: Self-adhering plastic films may leave residues that result in
rapid soiling after removal. Do not place plastic sheeting over any
carpet installation because it may present a slip hazard. Most
importantly, plastic coverings will trap moisture, retard adhesive
curing and may promote mold growth.
12.7.3 Maintain Temperature
Do not allow the temperature of carpeted areas to fall below 50
o
F (10
o
C),
regardless of the age of the installation.
13.0 Double Glue Down
13.1 Cushion Layout
Refer to manufacturer’s installation instructions. Install cushion in the longest
continuous lengths possible with consideration to traffic patterns and carpet seam
placement. It is required that cushion seams be at a right angle (90º) to carpet
seams or offset at least 6 inches (150 mm). Join cushion seams net without
compression, leaving no gaps. Do not tape or staple cushion seams for double glue
down installations.
NOTE: Cushions should be specifically designed for double glue
application and should not exceed 3/8 of an inch in thickness.
13.2 Carpet Layout
Refer to Section 5.3. Where applicable, allow for pattern repeat. Dry lay and align
all carpet breadths/widths to their proper position; and then trim seams. Take care
to avoid cutting into cushion under seams.
13.3 Adhesives and Trowel Notch Sizes
When applying cushion to substrate and carpet to cushion, select the appropriate
adhesive and trowel notch size recommended by the carpet, cushion and adhesive