User's Manual
Walkie‐talkie
T5UserManual
This set included 2 walkie-talkie units: there are communication devices which
operate on mobile on mobile radio frequencies. They come with 8/22(option)
channels as well as back-lit LCD screen, enabling you to communicate over several
kilometers free-of -charge (up to 5KM in open areas).
Note: Please read these user instructions carefully before using the equipment and
retain for future consultation!
Specific Recommendations
To avoid the risk of burns, do not use the device if the aerial is damage in any
way.
Don not use the device in a potentially explosive setting (e.g. Around pumps,
on the lower deck of a boat or around a fuel-storage installation or chemical
products).
If traveling in a car or by bike, stop before using the device.
Switch off the device if on an airplane or in a hospital.
Never use the device in close proximity to a radio that avoid to interference.
Remove the batteries if the device is not use for an extended period of time.
Never mix used with new batteries.
Position the transmitter and antenna at least 5cm from your face. Direct the
antenna upwards and speak normally.
Clean the device with a damp cloth. Avoid the use of cleaning agents and
solvents.
Do not modify the device in any way. In the event of damage occurring, ensure
that the device us checked by a qualified professional.
The device cannot be used to contact the emergency services.
Functional description
BEFORE USE
Removing the belt clip
Before insert batteries into the device, first pull the belt clip latch away from the
device.
Installing the Batteries
A. FOR USE OF NON RECHARGEABLE BATTERIES:
1. Slid down the battery compartment cover.
2. Insert 4* AAA Alkaline (Not included)
3. Position the batteries according to the polarity making on the battery
compartment.
4. After placing batteries into correct positions, replace the battery cover.
B.
FOR USE OF RECHARGEABLE BATTERIES WITH CRADLE AND ADAPTER
1. If your walkie-talkie comes with a cradle and wall charger, you should only use the
battery pack provided to charge. It cannot charge other type rechargeable batteries.
Using the device
1. Turning the device on/off
Switch on the device: Press and hold on the button 3 seconds then you will hear
a beep sound.
Switch off the device: Press and hold the button 3 seconds then you will hear a
beep sound.
2. Adjusting the volume
To increase the volume, press the Up ▲ button. And press the Down ▼ button to
decrease the volume.
3. Low Battery Indication
The device can detect the low battery level when the battery voltage goes low.
When battery voltage is low, the battery icon will flash and a beep will be heard to
indicate that the batteries need to be replaced.