BEFORE FIRST USE: Please leave the dehumidifier to stand outside the packaging for 24 HOURS before connecting 0 power, The dehumidifiers may have bean toted or placed upside down during shipping, Leave the dehumidifier to stand upright for 24 hours so the ofl in the compressor can settle from the move, nwt doing so can affect the performance or lifespan of the dehumidifier.
PARTS IDENTIFICATION Control Panel Air Outlet Access door Gravity Drain Outlet Remote Control Port Pump Drain Outlet Power Cord Port Handle Hand Screw Air Inlet Adjustable Foot MOTE: DO NOT OBSTRUCT THE AIR INLET AND/OR OUTLET.
OPERATION INSTRUCTIONS « 1. Position Your Dehumidifier @ Install the dehumidifier horizontally to minimize vibration and or noise, @® You can adjust the feet to level the dehumidifier. To adjust the feet, @® Turn the nut in a clockwise direction to get the nut loosen; @® Turn the foot in a clockwise direction to get the foot down or tum the footing counterclockwise direction to get the foot up; ® Turn the nut in a counterclockwise direction to fix the foot.
2. Set Up the Drainage {1) Drain by Internal Pump The dehumidifier has an internal pump that helps to drain the condensation water freely. When using the pump feature, + The Gravity Drain Outlet needs to be sealed by the included stopper; = Connect the drain hose to the Pump Drain Outlet; + Place the unattached end of the hose in a sink, bucket, pump sump, or out of a window anywhere that water can drain out safely.
4. Understand the Control Panel The control panel of the dehumidifier features a user-friendly interface with 4 buttons and an LED screen. Press the POWER Button to turn the dehumidifier on. After turning on the dehumidifier, the LED screen will display the readouts. Up Power/Purge LED Display Down Timing HH. is humidity percentage value. If no operations on the control panel, this number is the humidity readout of the inlet air the dehumidifier detects which is similar to the current room humidity level.
“: Defrosting icon: It illuminates when the dehumidifier detects frost on the interior. During defrosting, the fan operates while the compressor does not, and the defrost icon flashes until the frost melts. The dehumidifier will automatically begin to dehumidify and the “Defrost” icon will disappear once the defrosting process is complete. Note: Frequent defrosting indicates that the room temperature is too low. It is recommended to add heat when the room temperature is lower than 60°F for proper drying.
6, Timer Setting It enables you to either delay the auto-on or auto-off function of the dehumidifier from 1 to 24 hours, -Set AUTO-ON: When the dehumidifier is off, press the Timer button to set a desired time it begins to work. -Set the dehumidifier AUTO-OFF: When the dehumidifier is on, press the Timer button to set a desired time it shuts off. Set the TIMER by the Below Steps 1. Press the Timer Button and the Timer icon and value . lights up and flashes. 2.
MAINTENANCE To avoid possible electric shock, ensure to turn the dehumidifier off and disconnect the plug from the power source before performing any cleaning or maintenance. 1. Cleaning the Dehumidifier Clean the dehumidifier housing with a soft damp cloth. Do not submerge or place water on the dehumidifier or control panel. Water may damage the electronic components of the dehumidifier. Do not use chemical solvents such as benzene, alcohol, gasoline or other heavy-duty cleaners.
