OPERATION INSTRUCTIONS * 1. Position Your Dehumidifier + Make sure to install the dehumidifier experimentally to minimize vibration and/or noise. Importantly, prevents water leakage. + You can adjust the feet to level the dehumidifier. To adjust the feet, + Tum the nut in a clockwise direction to get the nut loosen; » Tum the foot in a clockwise direction to get the foot down or turn the foot in a counterclockwise direction to get the foot up; » Tum the nut in a counterclockwise direction to fix the foot.
, Set Up the Drainage (1) Drain by Internal Pump The dehumidifier has an internal pump that helps to drain the condensation water freely. When using the pump feature, + The Gravity Drain Outlet needs to be sealed by the included stopper; + Connect the drain hose to the Pump Drain Outlet; » Place the unattached end of the hose in a sink, bucket, pump sump, or out of a window anywhere that water can drain out safely.
4. Understand the Control Panel The control panel of the dehumidifier features a user-friendly interface with 4 buttons and an LED screen. Press the POWER Button to tum the dehumidifier on. After muting on the dehumidifier, the LED screen will display the readouts. Up Power/Purge LED Display Down Timing HR. is humidity percentage value. If no operations on the control panel, this number is the humidity readout of the inlet air the guide r detects which is similar to the current room humidity level.
#% Defrosting icon: It illuminates when the dehumidifier detects frost on the interior. During defrosting, the fan operates while the compressor does not, and the defrost icon flashes until the frost melts. The dehumidifier will automatically begin to dehumidify and the “Defrost” icon will disappear once the defrosting process is complete, Note: Frequent defrosting indicates that the room temperature is too low. It is recommended to add heat when the room temperature is lower than 60°F for proper drying.
6. Timer Setting It enables you to either delay the auto-on or auto-off function of the dehumidifier from 1 to 24 hours. Set AUTO-ON: When the dehumidifier is off, press the Timer button to set a desired time it begins to work. Set the dehumidifier AUTO-OFF: When the dehumidifier is on, press the Timer button to seat desired time it shuts off. Set the TIMER by the Below Steps 1. Press the Timer Button and the Timer icon and value ©. lights up and flashes. 2.
