Full Product Manual

MoJack EZ Lift

Operating Instructions

STEP 20

Raising the MoJack EZ with a power drill

(optional)

• The MoJack EZ can be raised or lowered by using a

variable speed corded drill (7 amp minimum) or variable

speed cordless drill (18V minimum).

• The drill will require a 3/8” square driver (not provided).

• Remove Crank Handle by taking out the nut and bolt

which reveals the 3/8” Square Receiver.

• Firmly insert the 3/8” driver in the Square Receiver.

Rotate the drill forward (clockwise) to raise

the Lift Arm and rotate the drill in reverse

(counterclockwise) to lower the Lift Arm.

• Carrier Locking Pin must be pulled out when

lowering until it clears the bottom Safety Hole.

• Follow all other operating instructions while using the

drill attachment.

• Replace the Crank Handle for future use.

Operator must have a rm grip on the drill before

raising or lowering the Lift Arm.

THE MOJACK EZ IS NOW READY FOR STORAGE OR TRANSPORT.

3/8”

Square

Driver

Square

Receiver

Screw

Thread

STEP 19

Folding the MoJack EZ

• Pull locking pin out to unlock.

• Raise the Tower out of the Base by pulling up on the

Grip Handle and then lower the Tower.

• The tower will be securely locked in place when the

locking pin retracts.

Tower Locking

(unlocked position)

Lift Tower

out of Base

Tower Locking

(locked position)