Full Product Manual

MoJack EZ Lift
8
Assembly Instructions
STEP 5
Nylock Nut
15
Carriage Bolt
13
Crank Handle
8
Tower
1
Attach the Crank Handle to the Tower by inserting
Carriage Bolt with threads facing up and fasten with
Nylock Nut .
Note: There are two holes in the Crank Handle. The hole
closest to the rubber grip will provide a 6” radius for crank-
ing. The other hole will provide an 8” radius, making crank-
ing easier. Use the hole that works best with your model of
lawn mower.
18
13
15
Hang the Lift Arm on the Carrier by
hooking the slotted area of the Lift Arm
over the top bar of the Carrier. Insert
Clevis Pin through the hole in
Carrier and lock by fastening the
Small Hair Pin to the Clevis Pin.
Lift Arm
2
Small Hair Pin
18
STEP 6
Clevis Pin
17
2
17
18
STEP 7
Large Hair Pin
19
Wheel Pad, RH
5
Support Rod
9
Ready the Wheel Pads & for installation by
adding Support Rods and Large Hair Pins .
Note: The Support Rods can be congured to t
several different tire sizes (see Support Rod Guide
for Tire Sizes on page 18). Use appropriate hole
conguration that works best for your model of
lawn mower.
5 6
9 19
STEP 8
Push Pin
16
Lift Arm
2
Wheel Pad, RH
5
Tower
1
Wheel Pad, LH
6
Slide the Wheel Pads & into the Lift Arm .
Insert Push Pins .
Note: The Wheel Pads can be moved in or out to t dif-
ferent mower widths. Use the conguration that works
best with your model of lawn mower.
5 6 2
16
THIS COMPLETES ASSEMBLY.
Tower
1
Top Bar
Carrier