User's Manual Part 4

STAR 3000 Installation Manual
Mojix Incorporated
www.mojix.com
[phone]
Figure
Installers will need the following set of tools to perform a proper GPIO installation.
• Medium-
size Phillips screw driver for the cover of the GPIO
• Small-
size Phillips screw driver for the GPIO terminal block connectors
•
Wire cutter to shorten connectors and/or connector cables (if necessary)
GPIO Cabling
The GPIO unit comes with the input ca
be daisy-chained together. Figure
17
block.
Figure
16: GPIO / eNode Physical Interface
Installers will need the following set of tools to perform a proper GPIO installation.
size Phillips screw driver for the cover of the GPIO
size Phillips screw driver for the GPIO terminal block connectors
Wire cutter to shorten connectors and/or connector cables (if necessary)
The GPIO unit comes with the input ca
ble pre-
installed, however, in the case where GPIO boxes ne
17
and Table 7 provide wiring and pin-
out details for the input terminal
Page
23
of
36
Confidential and Proprietary
installed, however, in the case where GPIO boxes ne
ed to
out details for the input terminal