User's Manual

STAR 3000 Installation Manual
Mojix Incorporated
www.mojix.com
[phone]
Page
12
of
45
Confidential and Proprietary
STAR RECEIVER INSTALLATION
STAR Receiver Installation
The STAR is mechanically designed for post or wall mounting. Figure 4 illustrates the rear mounting
bracket. This bracket is designed to be used with any standard VESA mounting bracket. As shown in the
figure, the mounting bracket is installed directly on the STAR Receiver back plate.
Installation instructions:
1. Product installation shall be conducted by a qualified installer. The appropriate local engineer or
architect shall be consulted to ensure the wall and/or pole mount is capable of safely supporting up to
4 times the weight of the product.
2. Should the customer elect to mount the STAR to a flat surface (e.g. wall), holes are provided in the
main mounting bracket to accommodate a family of hardware (customer supplied).
3. When mounting STAR unit to a flat surface, a minimum of 4 fasteners are required, though the exact
type is a function of the wall material and construction. Best industry practice is recommended.
a. For example: toggle bolts or Molly bolts would be the first choice on hollow walls. Lead lag
shields would be recommended on solid (cast) concrete or brick. Nails are not
recommended, but could be used only if the wood material of the wall was at least 1.5" thick.
4. The STAR Receiver is first secured to the main bracket using the provided hardware. A standard
VESA bracket designed to hold 4 times the weight of the STAR unit should separately be mounted to
either a mast or a flat surface. The last step is to attach the STAR bracket to the VESA bracket.
Figure 4: STAR 3000 VESA Interface Mount Bracket