User's Manual

STAR 3000 Installation Manual
Mojix Incorporated
www.mojix.com
[phone]
Page
22
of
45
Confidential and Proprietary
Figure 15: MCON Network Configuration
CHANGING STAR NETWORK SETTINGS
The STAR 3000 uses DHCP for IP addressing by default. If a DHCP server is not detected within 1
minute from power up, then there are 4 temporary IP addresses assigned and remain active for 10
minutes. These addresses are as follows:
• Default Ethernet 1 Address: 169.254.1.10
• Default Ethernet 1 Netmask: 255.255.0.0)
• Default Ethernet 1 Secondary Address: 10.254.1.10
• Default Ethernet 1 Secondary Netmask: 255.0.0.0
• Default Ethernet 2 Address: 169.254.1.11
• Default Ethernet 2 Netmask: 255.255.0.0
• Default Ethernet 2 Secondary Address: 10.254.1.11
• Default Ethernet 2 Secondary Netmask: 255.0.0.0
Network settings are stored in the following file on the system: /mnt/boot/etc/rc.conf
In order to edit this file, follow this procedure:
1. Power on the STAR 3000 with an Ethernet cable connected to Ethernet 1.