User's Manual

STAR 3000 Installation Manual
Mojix Incorporated
www.mojix.com
[phone]
Page
28
of
45
Confidential and Proprietary
Name The name of the Zone (unique name are required)
Start delta from default (dB) The power profile starts from the power defined in the
eNode page plus this delta. All levels are measured in dB.
Step Size (dB) This indicated how much the power will be adjusted for
each step size.
Num of Steps The configured the number of steps to perform.
Del If selected this row will be deleted on “Save”
Table 9: Power Diversity Configuration
Sensor Configuration
The Sensor configuration page is used to configure sensors that will be used by the eNodes. Sensors
are physically attached to the eNodes and this configuration is done on the eNode page. The Mojix-
optical sensor is the only sensor that is not physically attached but still requires a virtual binding to an
eNode.
Figure 21: Sensor Configuration page
Configuration Item Description
Name The name of the Sensor (unique names are required)
Type Configures the type of Mojix supported sensors
Del If selected this row will be deleted on “Save”
Table 10: Sensor Configuration
eNode Configuration
The eNode configuration page is used to configure every antenna on the Mojix system. Due to the
potential large size of deployment there is an easy sorting menu to assist in searching and finding the
necessary information. The interface supports filtering the information based upon the STAR and/or Zone
of interest. The Total entries indication is displayed showing the total number of antennas configured.