User's Manual Part 2
69
CHAPTER IV: MAKER
STARex MANUAL
TAG VIEWER
If no results are found the following message will display:
Below the mentioned buttons and above the results table, a code wheel, the number of Rounds and the number of Unique EPCs are displayed.
The Code Wheel allows the user to change the program (Basic and Advanced), it is disabled while the RFID program is running, once the program is
stopped, the code wheel is enabled. The label next to the code wheel shall correspond to the following:
- While running: Running Basic or Advanced: <lename>
- While stopped: Stopped Basic or Advanced: <lename>
- While paused: Paused Basic or Advanced: <lename>
Clicking in the Code Wheel will open a new dialog box and it is possible to change the program between Basic and Advanced. For the advanced settings
there is a list presented with the available program les resident in the STARex.