User's Manual

Mojix
®
STAR 1000 System User Manual
33
B.2 STAR System Cabling Example
The following figure illustrates an example, showing the cable lengths between each segment of an example
deployment. From the drawing, a measurement the insertion loss of each segment is computed, as shown in the
figure below. This information is used for placing the eMuxes, to maximize power distribution across all eNodes. Keep
in mind that cable runs need to run from eNode to eNode, but may also have to run up and down from the ceiling to
the eNode itself. In many cases, cabling may not run in a straight diagonal line as shown, but instead may need to run
along beams vertical or horizontal.
Figure 33: Example – Showing eNode, eMux and STAR cabling
Figure 34: Example Showing Cable Losses