Installation Instructions

C
-65 Installation Guide 8
Figure 2-2 Rear Panel of C-65
Table 2-3 Rear Panel Port Settings for C-65
Port Description Connector Type Speed/Protocol
12V DC
Enables you to connect to and power on device
using 12 V DC power with 2.5 ampere.
--
--
Ethernet
(LAN/PoE)
Enables you to connect the device to a wired
LAN through a switch or a hub. The device can
then communicate with the server.
This port also provides the power for the device
using the 802.3af standard
RJ45
10/100/1000 Mbps
Ethernet
Power over Ethernet
The Reset Pin Hole is shown in the figure above. The Reset Pin Hole resets the C-65 device to factory defaults.
To reset the device, power cycle the device (remove the power cable once and connect it back again) and while
plugging the power cable back into the power source, press and hold down the Reset Pin Hole for 45 seconds
until the power, LAN1, 2.4 GHz LEDs go green. Pressing the Reset Pin Hole while the device is running will not
have any effect. When you reset the device, the following settings are reset:
• Config shell password is reset to config.
• Server discovery value is erased and changed to the default, wifi-security-server.
• All the VLAN configurations are lost.
• Device mode is changed to Sensor Only.
• If static IP is configured on the device, the IP address is erased and DHCP mode is set.
After reset, all the LEDs will blink once, indicating that the reset is successful, and the system boot sequence is
initiated.