Installation Instructions

C
-65 Installation Guide 12
Figure 3-3. Power Up and Connect C-65 using PoE
Using C-65 with power adapter
To power up the device, perform the following steps:
1. Plug the power cable into the DC power receptacle at the rear of the device.
2. Plug the other end of the power cable into an 110V~240V 50/60 Hz AC power source.
Wait until the device is ready. Refer to the respective LED details table based on the configured device
mode.
Figure 3-4. Power Up C-65
To connect C-65 to the network, perform the following steps:
1. Ensure that a DHCP server is available on the network to provide network configuration to the C-65.