Installation Instructions

C
-65 Installation Guide 13
2. Connect one end of the network interface cable to the Ethernet port at the rear of the C-65.
3. Connect the other end of the network interface cable to an Ethernet jack on the desired subnet.
Wait until the device is ready (approx. 10 mins).
Figure 3-5. Connect C-65 to network
4. Check the status LEDs on the device. If all LEDs glow green, then the device is operational and
connected to the server.
5. Log on to the server through SSH and run the get sensor list command.
You would see a list of all AirTight devices that are recognized by the server. AirTight Cloud Services
users can go to the Devices tab and check whether the device is visible under the Devices tab.
The device is configured and ready to go operational.
Note: If the zero configuration is not successful, the device must be configured manually. Refer to
Manually
Configuring C-65 for details.