Installation Instructions

C
-65 Installation Guide 19
Table 5-2. set Commands
set Commands
Command
Description
set erase
Sets the erase character to ^H.
set interface
Sets network interface properties such as auto negotiation, speed, and duplex settings.
set ip config
Runs through the current VLAN and IP config wizard.
set server
discovery
Sets the server discovery information.
set vlan config
Configures list of VLANs and their network settings, to be monitored by ND.
set ipv6 config
Sets IPv6 network settings.
set
communication
key
Sets the AP-server shared secret. You must enter a hexadecimal value, of length 32,
as the shared secret. It can be used instead of the set communication
passphrase command. Use this command if you are comfortable working with
hexadecimals.
set
communication
key default
Sets the communication key to its default value.
set
communication
passphrase
Sets the AP-server shared secret. You must enter a character string, of length between
10 and 127, as the shared secret. The string is internally converted to hexadecimal
format. It can be used instead of the set communication key command.
set presence
notification
parameters
Sets the presence notification parameters. The parameters for presence notification
are the RSSI value in dbm, IP address/hostname of the presence notification server
and time interval in seconds. The RSSI value can range between -127 and 0 dbm. The
time interval can range between 0 and 14400 seconds.