User's Guide

AirTight Management Console User Guide
172
3.
Select the Customize Additional VLANs to monitor check box.
4. Specify the additional VLANs to be monitored as a comma-separated list.
5. Change the communication VLAN, if needed. 0 is the communication VLAN. However, you can
specify another number as the communication VLAN. Before the 6.7 Update 5 release, the
communication VLAN was set from the CLI only with the set vlan config command.
Note: Prior to the 6.7 Update 5 release, the communication VLAN could be only set from the CLI.
From the 6.7 Update 5 release, it can be done from the AirTight Management Console.
IMPORTANT: After the communication VLAN has been set from the UI, it cannot be modified from
the CLI. If you have set an incorrect communication VLAN from the UI, and want to change it, you
have to first do a factory reset of the AirTight device, and then set the correct communication
VLAN.
6.
Click Advanced to do advanced operations such as editing the VLAN properties of the additionally
monitored VLANs and to repush the IP settings of these VLANs on to the AP or WIPS sensor.
a)
To edit the VLAN properties of the VLANs, click Edit. Change the addressing mechanism to static
or DHCP as required and save the change.
b)
To re-push the revised IP settings of the additionally monitored VLANs on to the AirTight device,
click Repush and then Save. If you want to cancel the repush, click Cancel before you click Save.
The text on the link changes to repush pending until an acknowledgement is received from the
AirTight device.