User's Guide

AirTight Management Console Configuration
75
Under connection capability, you can specify the protocols supported by the network connection and the
corresponding port numbers and whether the port is open or closed. These settings signify the
capabilities of the wired network that the AP is connected to. They provide information on the connection
status of the most commonly used communication protocols and ports within the hotspot.
Configure Hotspot 2.0 Settings
To configure Hotspot 2.0 Settings, do the following.
1.
Select the Hotspot 2.0 tab in the Add Wi-Fi Profile or Edit Wi-Fi Profile dialog box.
2. Configure the General Settings.
Field Description
Network
Type
Select the appropriate network type that the AP is a part of, from the list of
available options.
Network
Auth Type
Select the network authentication type from the list of available options.
IPv4
Address
Select the appropriate IPv4 address type from the available options. The
following options are available.
Address type not available
Public IPv4 address available
Port-restricted IPv4 address available
Single NATed private IPv4 address available
Double NATed private IPv4 address available
Port-restricted IPv4 address and single NATed private IPv4 address
available
Port-restricted IPv4 address and double NATed private IPv4 address
available
For NAT related options, NAT must be enabled on the Wi-Fi profile.
Internet
Access
Select this check box if the network provides Internet access to the client
through the AP.
HESSID
Homogenous Extended Service Set Identifier. This is an optional field
used to identify hotspot APs. APs with the same HESSID have the same
Hotspot 2.0 configuration.
Redirect
URL
URL to which the user is to be redirected on connecting to the AP. This
field is used in conjunction with network authentication type.
IPv6
Address
Select the appropriate IPv6 address type from the available options. The
following options are available
Address type not available
Address type available
Availability of address type not known
3. Enter the roaming consortium list using hex characters. The first 3 roaming consortium from
the list are advertised in the beacon. Up to 32 roaming consortiums can be added here. The
length of the roaming consortium string must be 3 or 5 bytes, that is 6 or 10 hex characters.
4.
Enter the venue details as described in the following table and click Add for each venue
information that you add.
Field Description
Venue
Group
Select the appropriate venue group from the available options.
Venue
Type
Select the type of venue at which the AP is installed. Different options are
presented based on the venue group selected.
For example, when you select the venue group as Educational, the