User's Manual

ManuallyȱConfiguringȱtheȱSensorȱ

SpectraGuard

ȱEnterpriseȱInstallationȱGuideȱ

34ȱ

x SNDCȱMode:ȱThisȱmodeȱneedsȱtoȱbeȱexplicitlyȱconfigured.ȱInȱthisȱmode,ȱtheȱSensorȱshouldȱbeȱconnectedȱintoȱaȱ

trunkȱportȱ(802.1Qȱcapable)ȱonȱaȱswitch.ȱItȱthenȱmonitorsȱmultipleȱVLANsȱthatȱareȱconfiguredȱonȱthatȱtrunkȱportȱandȱ

areȱchosenȱbyȱtheȱuserȱusingȱtheȱNDȱCLI.ȱTheȱwireless

ȱinterfaceȱofȱtheȱSensorȱisȱenabled.ȱAȱSensorȱinȱSNDCȱmodeȱ

canȱmonitorȱupȱtoȱ4ȱVLANsȱandȱdetectȱupȱtoȱ4ȱVLANs.ȱ

UseȱtheȱsetȱmodeȱcommandȱtoȱsetȱtheȱSensorȱmode.ȱ

Figure 59. set sensor mode command

6.2.5 ConfigureȱNetworkȱSettingsȱ

Onceȱtheȱmodeȱisȱset,ȱyouȱhaveȱtoȱenableȱtheȱNetworkȱSettings.ȱ

x SensorȱOnlyȱMode:ȱForȱthisȱmode,ȱuseȱtheȱcommandȱsetȱipȱconfig.ȱThisȱcommandȱrunsȱthroughȱtheȱcurrentȱVLANȱ

andȱtheȱIPȱconfigȱwizard.ȱ

x NetworkȱDetector/Sensor/NDȱComboȱMode:ȱForȱthisȱmode,ȱuseȱtheȱcommandȱsetȱvlanȱconfig.

ȱThisȱcommandȱ

configuresȱtheȱIPȱaddressesȱonȱtheȱND.ȱ

ReferȱtoȱChapterȱ3:ȱGuidelinesȱforȱConfiguringȱandȱInstallingȱNDȱandȱSNDCȱinȱtheȱdocumentȱ‘NetworkȱDetectorȱ

ConfigurationȱforȱSpectraGuardȱEnterprise_5.7’ȱforȱfurtherȱdetails.