User's Manual

ConfigȱShellȱCommandsȱ
SpectraGuard
®
ȱEnterpriseȱInstallationȱGuideȱ
91
Chapterȱ8 ConfigȱShellȱCommandsȱ
8.1 ServerȱConfigȱShellȱCommandsȱ
ThisȱchapterȱdescribesȱtheȱcommandsȱinȱtheȱServerȱConfigȱShellȱusedȱtoȱreconfigureȱorȱmaintainȱtheȱServerȱafterȱrunningȱtheȱ
ServerȱConfigurationȱWizard.ȱSomeȱcommandsȱdisplayȱtheȱstatusȱofȱtheȱServer.ȱ
Database Commands
Command Description
db backup
Backs up the database to the Remote Server specified by
you
db clean Resource clean-up without disruption of services
db maintain Resource clean-up after temporary shutting down of services
db reset
Resets the database to factory defaults but maintains
network settings
db restore
Restores the database from a previous backup on a Remote
Server
ȱ
get Commands
Command Description
get allowed ip
Displays the list of IP addresses or subnets that are allowed
to access this device
get cert Generates a self-signed certificate
get certreq Generates a Certificate Signing Request (CSR)
get date Displays the current time zone, date, and time on the Server
get debug
Creates a debug information ‘tarball’ file; this file can be
used for debugging purposes
get ha
Displays High Availability (HA) Cluster configuration and
service status
get ha help Displays detailed High Availability (HA) setup help
get interface Displays the Network and HA Interface speed and mode
get locationinfo
Extracts information about location hierarchy, imported
images, and signal strength for all devices seen by Sensor
get log config Displays the configuration of the logger
get monitoring
Displays the number of days that the system should keep
the data for all performance monitoring charts
get network
Displays the Network Interface (eth0) configuration including
the IP Address, Subnet mask, Gateway, DNS Address, and
DNS Prefix
get opsec log Displays the log messages generated by OPSEC API
get route Displays the routing table