Manualshelf

Data Sheet

ManualsBrandsMOKO TECHNOLOGY ManualsElectronicsBluetooth Low Energy Module
19202122232425262728
MK02 Bluetooth Module
Datasheet
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
2.9 Information on test modes and additional testing requirements
Data transfer module demo board can control the EUT work in RF test mode at specified test channel.
2.10 Additional testing, Part 15 Subpart B disclaimer
The module without unintentional-radiator digital circuit, so the module does not required an evaluation by FCC Part 15 Subpart B. The
host should be evaluated by the FCC Subpart B.
ATTENTION
This device is intended only for OEM integrators under the following conditions:
1) The
antenna must be installed such that
5mm is maintained between the antenna and users
2) This device and its antenna(s) must
not be co‐ located with any other transmitters except in accordance with FCC multi‐
transmitter
product procedures. Referring to the multi‐ transmitter policy, multiple transmitter(s) and module(s) can be operated simultaneously
without C2P.
3) For all products market in US, OEM has to limit the Operating Frequency: 2402MHz - 2
480MHz by supplied firmware programming
2
4
www.mokoblue.com
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM Manual v01
2.4 Limited module procedures
not applicable; Single Modular Approval Request
2.5 Trace antenna designs
not applicable
2.6 RF exposure considerations
The equipment complies with FCC Radiation exposure limits set forth for uncontrolled environment.
This equipment should be installed and operated with minimum distance 5mm between the radiator and your body.
2.8 Label and compliance information
The final end product must display the following content in the visible area
Host must Contains FCC ID: 2AO94-MK02. If the size of the end product is larger than 8x10cm, then the following FCC part
15.19 statement has to also be available on the label: This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions: