Data Sheet

MK06 Bluetooth Module

Datasheet

www.mokoblue.com

6.2.2 RF exposure

All transmitters regulated by IC must comply with RF exposure requirements listed in RSS-102 - Radio

Frequency (RF) Exposure Compliance of Radiocommunication Apparatus (All Frequency Bands). This

module is approved for installation into mobile and/or portable host platforms and must not be co-

located or operating in conjunction with any other antenna or transmitter except in accordance with

Industry Canada's multi-transmitter guidelines. End users must be provided with transmitter

operating conditions for satisfying RF Exposure compliance.

6.3 European Union regulatory compliance

Information about regulatory compliance of the European Union for the MK06 module is available

in the MK06 Declaration of Conformity.

6.3.1 Radio Equipment Directive (RED) 2014/53/EU

The MK06 module complies with the essential requirements and other relevant provisions of Radio

Equipment Directive (RED) 2014/53/EU.

6.3.2 Labeling and user information requirements

The label on the final products which contain the MK06 module must follow CE marking

requirements. The “R&TTE Compliance Association Technical Guidance Note 01” provides guidance

on final product CE marking.

6.4 Japan (MIC)

The MK06 module has received type certification and is labeled with its own technical conformity

mark and certification number as required to conform to the technical standards regulated by the

Ministry of Internal Affairs and Communications (MIC) of Japan pursuant to the Radio Act of Japan.

Integration of this module into a final end product does not require additional radio certification

provided installation instructions are followed and no modifications of the module are allowed.

Additional testing may be required:

• If the host product is subject to electrical appliance safety (for example, powered from an AC

mains), the host product may require Product Safety Electrical Appliance and Material (PSE) testing.

The integrator should contact their conformance laboratory to determine if this testing is required.

• There is a voluntary Electromagnetic Compatibility (EMC) test for the host product administered

by VCCI: http://www.vcci.jp/vcci_e/index.html

The label on the end product which contains a MK06 module must follow the MIC marking

requirements. Labeling requirements for Japan available at the Ministry of Internal Affairs and

Communications (MIC) website: http://www.tele.soumu.go.jp/e/index.htm.