MSDS

12/11/2007Revision:
12/11/2007Printed:
3Page:
Mold Armor Instant Mold & Mildew Stain
Remover
MATERIAL SAFETY DATA SHEET
10/03/2007Supercedes Revision:
6. Accidental Release Measures
Clean-up:
Keep unnecessary people away, isolate hazard area and deny entry. Stay upwind, out of low areas, and ventilate
closed spaces before entering.
Small spills:
Take up the spilled liquid with sand, earth, or other noncombustible absorbent material and place in a plastic
container where applicable.
Large spills:
Dike far ahead of spill for later disposal.
Keep material out of sewers, storm drains, surface waters, and soil. Sodium hypochlorite is very toxic to aquatic
life.
Steps To Be Taken In Case Material Is Released Or Spilled
7. Handling and Storage
Read carefully all cautions and directions on product label before use. Since empty container retains residue,
follow all label warnings even after container is empty. Dispose of empty container according to all regulations.
Do not reuse this container.
Precautions To Be Taken in Handling
Keep container tightly closed when not in use. Store in a cool, dry place. Protect from freezing. Avoid extreme
high or low temperatures.
Precautions To Be Taken in Storing
8. Exposure Controls/Personal Protection
For OSHA controlled work place and other regular users -- Use only with adequate ventilation under engineered
air control systems designed to prevent exceeding appropriate TLV. For occasional use, where engineered air
control is not feasible, use properly maintained and properly fitted NIOSH approved respirators. A dust mask
does not provide protection against vapors.
Respiratory Equipment (Specify Type)
Safety glasses, chemical goggles or face shields are recommended to safeguard against potential eye contact,
irritation, or injury. Contact lenses should not be worn while working with chemicals.
Chemcial splash goggles or safety glasses with a faceshield should be worn if the possibility of splashing exists.
Eye Protection
Wear impermeable gloves. Gloves contaminated with product should be discarded. Promptly remove clothing
that becomes soiled with product.
Protective Gloves
Various application methods can dictate use of additional protective safety equipment, such as impermeable
aprons, etc., to minimize exposure. Before reuse, thoroughly clean any clothing or protective equipment that has
been contaminated by prior use. Discard any clothing or other protective equipment that cannot be
decontaminated, such as gloves or shoes.
Other Protective Clothing
Use only with adequate ventilation to prevent build-up of vapors. Open all windows and doors. Use only with a
cross ventilation of moving fresh air across the work area. If strong odor is noticed or you experience slight
dizziness, headache, nausea, or eye-watering -- Stop -- ventilation is inadequate. Leave area immediately.
Engineering Controls (Ventilation etc.)
Licensed to W.M. Barr and Company
ANSI Z400.1 Format