SDS

04/10/2018Revision:
04/10/2018Printed:
Page: 5
Mold Armor Pre-Paint Cleaner1
SAFETY DATA SHEET
02/15/2018Supersedes Revision:
Additional Regulatory
Information
This chemical is a pesticide product registered by the United States Environmental
Protection Agency and is subject to certain labeling requirements under federal pesticide
law. These requirements differ from the classification criteria and hazard information
required for safety data sheets (SDS), and for workplace labels of non-pesticide
chemicals. The hazard information required on the pesticide label is reproduced below.
The pesticide label also includes other important information, including directions for use.
Precautionary statements: Hazards to Humans and Domestic Animals
WARNING: Causes moderate eye irritation. Do not get on skin or on clothing. Avoid
contact with eyes. Wear waterproof gloves and appropriate clothing. Wash thoroughly
with soap and water after handling and before eating, drinking, chewing gum, using
tobacco or using the toilet. Remove and wash contaminated clothing before reuse.
First Aid: If in eyes: Hold eye open and rinse slowly and gently with water for 15-20
minutes. Remove contact lenses, if present, after the first 5 minutes, then continue
rinsing the eye.
If on skin or clothing: take off contaminated clothing. Rinse skin immediately with plenty
of water for 15-20 minutes.
Call a poison control center or doctor for treatment advice. Have the product container or
label with you when calling a poison control center or doctor, or going for treatment.
[National Poison Control Center: 1-800-222-1222].
Physical and Chemical Harzards
This product contains an oxidizing agent. Do not use or mix with other chemicals such
as toilet bowl cleaners, rust removers or any cleaners containg acids or ammonia as
hazardous gases may be released. Prolonged contact with metal may cause pitting or
discoloration.
16. OTHER INFORMATION
No data available.
Additional Information About
This Product:
Company Policy or
Disclaimer:
04/10/2018
Revision Date:
W.M. Barr EHS Dept (901)775-0100
Preparer Name:
Licensed to W.M. Barr and Company: MIRS MSDS, (c) A V Systems, Inc.
GHS format