User Manual

1. Hold respirator in hand with molded nose
contour (narrow end) at finger tips, allowing
headstraps to fall below hand.
2. Place respirator under chin with molded
nose contour (narrow end) up. Nose cushion
must not be creased inside of respirator.
Raise top strap to top back of head. Pull
shorter bottom strap over head, below ears,
to around neck. Do not wear with only one
strap. When changing from any model/size to
another respirator, you must fit test.
3. Adjust respirator for comfortable fit.
4. Each time before entering a contaminated
area, perform a user seal check. Cover front of
respirator by cupping both hands. INHALE
SHARPLY. A negative pressure should be felt
inside respirator. If any leakage is detected at
respirator edges, adjust straps by pulling back
along the sides and/or reposition respirator.
Repeat until sealed properly, otherwise see
your supervisor. Entry into a contaminated
area with an improper fit may result in sick-
ness or death.
1. Attach buckle behind neck with shell
against chest.
2. a) Fit mask to face and pull top of strap
to crown of head. Nose cushion must
not be creased inside of respirator.
b) Always use top and bottom part of
strap. Adjust tension for a comfortable
fit. When changing from any model/size
to another respirator, you must fit test.
3. Each time before entering a contaminated
area, perform a user seal check. Cover front
of respirator by cupping both hands. INHALE
SHARPLY. A negative pressure should be felt
inside respirator. If any leakage is detected at
respirator edges, adjust straps by pulling back
along the sides and/or reposition respirator.
Repeat until sealed properly, otherwise see
your supervisor. Entry into a contaminated
area with an improper fit may result in sick-
ness or death.
4. To hang around neck:
a) Undo buckle.
b) Allow strap to fall around neck.
c) Pull mask down to chest.
OR
b) Pull top strap forward away from head.
c) Adjust tension to allow mask to
hang freely.
2-Strap
HandyStrap
Adjustable 2-Strap
1. If necessary, untwist straps. Thread
bottom strap through bottom buckle and
repeat for top strap. Hold respirator in hand
with nose contour (narrow end) at finger tips,
allowing headstraps to fall below hand.
2. Place respirator under chin with molded
nose contour (narrow end) up. Nose cushion
must not be creased inside of respirator.
Raise top strap to top back of head. Pull
shorter bottom strap over head, below ears,
to around neck. Do not wear with only one
strap. When changing from any model/size
to another respirator, you must fit test.
3. Adjust tension on both top and bottom
straps to provide a tight and comfortable
seal. To tighten, pull ends of straps. To
loosen, push open hinge of buckle with
thumb and pull on strap.
4. Each time before entering a contaminated
area, perform a user seal check. Cover front of
respirator by cupping both hands. INHALE
SHARPLY. A negative pressure should be felt
inside respirator. If any leakage is detected at
respirator edges, adjust straps by pulling back
along the sides and/or reposition the respira-
tor. Repeat until sealed properly, otherwise do
not enter work area and see your supervisor.
Entry into a contaminated area with an
improper fit may result in sickness or death.
®
Turn over for EZ-ON and SmartStrap respirators