User Manual

2. Place respirator under chin with molded
nose contour (narrow end) up. Nose cushion
must not be creased inside of respirator. Pull
head harness to top of head so it rests at
the crown.
4. Each time before entering a contaminated
area, perform a user seal check. Cover front of
respirator by cupping both hands. INHALE
SHARPLY. A negative pressure should be felt
inside respirator. If any leakage is detected at
respirator edges, adjust straps by pulling back
along the sides and/or reposition respirator.
Repeat until sealed properly, otherwise see your
supervisor. Entry into a contaminated area with
an improper fit may result in sickness or death.
3. Adjust tension by pulling on each side of
strap within the head harness to provide a
tight and comfortable seal.
1. Hold respirator in hand with molded nose
contour (narrow end) at finger tips, allowing
headstraps to fall below hand.
AirWave
SmartStrap
EZ-ON
2. Place strap around neck so outside of
shell is against chest.
3. a) Fit mask to face and pull top of strap to
crown of head. Nose cushion must not
be creased inside of respirator.
b) Always use both top and bottom strap.
4. To tighten strap pull both strap tabs.
To loosen, grasp both sides of neck strap
and pull.
5. Each time before entering a contaminated
area, perform a user seal check. Cover front of
respirator by cupping both hands. INHALE
SHARPLY. A negative pressure should be felt
inside respirator. If any leakage is detected at
respirator edges, tighten or adjust strap by
pulling back along the sides and/or reposition
respirator. Repeat until sealed properly, other-
wise see your supervisor. Entry into a contami-
nated area with an improper fit may result in
sickness or death.
6. To hang around neck, pull top strap away
from head, then pull mask down.
MOLDEX-METRIC, INC.
Moldex-Metric, Inc.
10111 West Jefferson Blvd.
Culver City, CA 90232
TEL: [phone]
or [phone]
FAX: [phone]
E-mail: [e-mail]
www.moldex.com
AUSTRALIA
Unit 30/14-16 Stanton Road,
Seven Hills, NSW 2147
TEL: [phone]
FAX: [phone]
E-mail: [e-mail]
www.moldex.com
Moldex Technical Service Department:
[phone] or
[phone] ext. 512/550
Moldex, Ideas that wear well, AirWave, EZ-ON, HandyStrap, SmartStrap and the
PVC-Free logo are registered trademarks. The Mesh design and Waved design are
trademarks of Moldex-Metric, Inc. Made in U.S.A.
9900-037 REV B 12/14
NEW ZEALAND
3 Spence Road
Henderson, Auckland, NZ
TEL: [phone]
FAX: [phone]
E-mail: [e-mail]
www.moldex.com
1. Pull adjustment clip and strap fully below
the bottom of the mask.
®
Turn over for 2-Strap, HandyStrap and Adjustable respirators
®
®