MSDS

ManualsBrandsMoldex ManualsPaint1 gal. Mold Killer

EnviroCare Corporation Version # 1 [Revision Date: 11/13/2013]

MSDS

1 / 4

MATERIAL SAFETY DATA SHEET

MOLDEX

DISINFECTANT

Section 1: Product and Company Identification

Trade Name:

MOLDEX

DISINFECTANT

EPA No.

1839-83-82480

Product Class:

Quaternary Ammonium Compound

Product Use: RTU – Ready to Use Disinfectant

Sold By: EnviroCare Corporation

10 Upton Drive

Wilmington, MA, 01887

Telephone

Numbers:

24 hr. Emergency Assistance: Chemtrec 1-800-424-9300 (US/Canada); 1-703-527-3887 (Intl/Maritime)

Product or Company Information: 1-978-658-0123 (Mon – Fri)

Section 2:

Composition / Information on Ingredients

CAS #

Wt %

Diethylene glycol monobutyl ether 112-34-5 8

Alkyl (68% C12, 32% C14) dimethyl ethylbenzyl ammonium chloride (Alt CAS#

68956-79-6)

85409-23-0 0.105

Alkyl dimethyl benzyl ammonium chloride (C12-18) 68391-01-5 0.105

Section 3: Hazards Identification

Emergency Overview Contact with eyes and skin may cause irritation

Potential Health Effects

Eyes Contact with eyes may cause irritation.

Skin Contact with skin may cause irritation.

Inhalation May cause irritation of respiratory tract.

Ingestion

Ingestion of large amounts may produce gastrointestinal disturbances including irritation, nausea,

and diarrhea.

Section 4: First Aid Measures

First aid procedures

Eye contact

Immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention if

irritation develops or persists.

Skin contact

For skin contact flush with large amounts of water. Immediately take off all contaminated clothing.

If irritation persists get medical attention. Wash clothing separately before reuse.

Inhalation

If symptoms are experienced, remove source of contamination or move victim to fresh air. If the

affected person is not breathing, apply artificial respiration. If breathing is difficult, give oxygen.

Get medical attention immediately.

Ingestion

If ingestion of a large amount does occur, seek medical attention. Do NOT induce vomiting.

Section 5: Fire Fighting Measures

Extinguishing media

Suitable extinguishing

media

Protection of firefighters

Protective equipment

and

precautions for

firefighters

Hazardous combustion

products

Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2).

As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH

(approved or equivalent) and full protective gear.

Not available.

Summary of content (4 pages)

PAGE 1
MATERIAL SAFETY DATA SHEET MOLDEX® DISINFECTANT Section 1: Product and Company Identification Trade Name: MOLDEX® DISINFECTANT EPA No. 1839-83-82480 Product Class: Quaternary Ammonium Compound Product Use: RTU – Ready to Use Disinfectant Sold By: EnviroCare Corporation 10 Upton Drive Wilmington, MA, 01887 Telephone Numbers: 24 hr.
PAGE 2
Section 6: Accidental Release Measures Personal precautions Isolate area. Keep unnecessary personnel away. Stay upwind. Keep out of low areas. Ventilate closed spaces before entering. Environmental precautions Prevent further leakage or spillage if safe to do so. Methods for containment Methods for cleaning up Prevent entry into waterways, sewers, basements or confined areas Wear appropriate protective equipment and clothing during clean-up.
PAGE 3
Section 11: Toxicological Information Toxicological Data Components Diethylene glycol monobutyl ether (112-34-5) Test Results Acute Dermal LD50 Rabbit: 2700 mg/kg Acute Oral LD50 Guinea pig: 2000 mg/kg Acute Oral LD50 Mouse: 2400 mg/kg Acute Oral LD50 Rabbit: 2200 mg/kg Acute Oral LD50 Rat: 4500 mg/kg Acute Other LD50 Mouse: 850 mg/kg Acute Other LD50 Rat: 500 mg/kg Section 12: Ecological Information Ecotoxicological data Components Test Results Diethylene glycol monobutyl ether (112-34-5) LC50 Bluegil
PAGE 4
Section 16: Other Information Further Information HMIS® is a registered trade and service mark of the NPCA HMIS® ratings Health: 1 Flammability: 1 Physical Hazard: 0 Personal Protection: X NFPA ratings Health: 1 Flammability: 1 Instability: 0 Disclaimer Terms and Conditions. This MSDS is designed only as guidance for the products to which it applies.