Operation Manual

User Manual
17
Picture 5-27
5.2.6.3 PTZ Setup
Picture 5-29
5.2.6.4 Mobile
The DVR is currently compatible with mobile phones running Andriod, Windows Mobile and Symbian
operating systems on 3G networks. Details access methods please refer to separate Mobile phone Access
Instruction.
。
Picture 5-30
5.2.6.5 Motion Detection
Click [MainDeviceMotion] to enter into the [Motion Detection] menu shown as Picture 5-31. The [Motion
detection] Menu has three sections, including Channel Status, Sensitivity and Motion area.
Enter into [Main menuDevice PTZ Setup] to select the
channel you want to control and set PTZ protocol (Pelco-D or
Pelco-P), Baud Rate (1200, 2400, 4800, 9600), Stop bit (1, 2), Parity
Check (None, Odd, Even Mark Space), Address Code and Cruise
status respectively. Please note the above mentioned channel settings
must match with the settings of the PTZ camera.
 Channel STATUS: This option allow you enable motion detection on
any channel.
 SENSITIVITY: This option allows you to set sensitivity level of motion
detection from 1 to 4 with 4 being the most sensitive.
 MD AREA: This option allows you select the area you want to be
sensitive to motion.
Click [Main menuDeviceMobile] to enter into [Mobile]
menu shown as Picture 5-30.
Picture 5-31