Operation Manual

User Manual
21
If in the 16-split mode, the display show as below:
Channel (CH1~16)
5.5 PTZ Control
Picture 5-44
Picture 5-45
 Channel select: select the channel with the PTZ camera
 Total: set up pre-set bit quantity
 Cur Point: indicates starting point cruised. System default point is 01.
 Stop time: sets the stop time at each point
 GOTO: allow you go to a specific preset point.
 Set: allow you set a set of specific preset points of a PTZ camera.
1. Select a camera you desire to set a preset point;
2. Adjust the camera in a desired direction
3. Click [Set] to set the point as preset point
4. Click [Save] to save the preset point
5. Follow the above step to add one more preset point.
 Clean: allow you delete one selected preset.
 Note: Up to 254 presets bit for the model can be stored. However, actual preset quantity differs depending
on PTZ performance.
We introduced setting PTZ parameters previously in chapter 5.2.6.3.
Here we will discuss how to operate PTZ controls.
Pop up the Pop-up Menu to highlight and enter into [PTZ control] menu
(shown as Picture 5-44). Now user can control the camera with Pan, Tilt and
Zoom capabilities.
Click [Zoom-/+] button to zoom in / out the image; Click [Focus -/+]
button to focus the image; Click [Iris -/+] button adjust iris to open or close.
Cruise set
Open auto cruise function on PTZ setting menu if you want to
setup cruise function (system default: off), and set up cruise channel,
cur point and total quantity and stop time etc.