Manual

ManualsBrandsMonarch Instrument ManualsEquipmentF2A3X

1 Nov 26 2012 AJW Rev 0.92

F2A3X Frequency to Analog Converter Module

Instruction Manual

MONARCH INSTRUMENT

15 Columbia Drive

Amherst, NH 03031 USA

Phone: (603) 883-3390

Fax: (603) 886-3300

E-mail: support@monarchinstrument.com

Website: www.monarchinstrument.com

Summary of content (6 pages)

PAGE 1
F2A3X Frequency to Analog Converter Module Instruction Manual MONARCH INSTRUMENT 15 Columbia Drive Amherst, NH 03031 USA Phone: (603) 883-3390 Fax: (603) 886-3300 E-mail: support@monarchinstrument.com Website: www.monarchinstrument.com 1 Nov 26 2012 AJW Rev 0.
PAGE 2
Safeguards and Precautions 1. Read and follow all instructions in this manual carefully, and retain this manual for future reference. 2. Do not use this instrument in any manner inconsistent with these operating instructions or under any conditions that exceed the environmental specifications stated. 3. Be sure the power supplied to this instrument matches the specification indicated on the rear panel of the instrument 4.
PAGE 3
Contents 1. OVERVIEW ...................................................................................................................... 3 2. INSTALLATION ................................................................................................................ 4 2.1. Connections.................................................................................................................... 4 3 2.1.1. Power ...................................................................................
PAGE 4
@DAC1/FSCAL = xxx.xx 2. INSTALLATION The F2A1X Frequency to Analog module is housed in a DIN Rail mountable ABS enclosure 112 x 100 x 23 mm (4.4 x 3.9 x 1 inches). There are screw terminal connections on both ends of the unit. The module snaps onto a standard DIN Rail by clipping the non-metallic “hook” at the base of the module into one edge of the rail then pushing the module home allowing the metal spring clip to secure the module.
PAGE 5
7 2.1.2. Analog Out The Analog Output from the unit is connected to the 4 way terminal block marked ANALOG OUT POWER IN. Refer to Figure 2.1 above – Right Side view. The Analog Out are the two left hand terminals and source fthe voltage or current output as ordered. These terminals are polarity sensitive and are marked - and + accordingly. Ordering Information NOTE: The ANALOG OUTPUT COMMON is isolated from the other COM connections. The ANALOG OUT is an OUTPUT.
PAGE 6
Typical connections for Monarch standard sensors is shown below (The PO terminal is not shown): Power LED Indicator – Lit when power is present. Input Pulse Indicator – Mimics the input pulse. If the input frequency is high it will appear on constantly. Alarm Indication – Lit when an alarm condition occurs. May remain lit depending on how the alrm is set up. Alarm Cancel button – press to reset output relays.