MONARCH INSTRUMENT Instruction Manual SPSR-115/230 SPSR-115/230 Self-Powered Sensor TTL Pulse Output Printed in the U.S.A. Copyright 2013, Monarch Instrument, all rights reserved 1071-4847-115R 0113 15 Columbia Drive Amherst, NH 03031 USA Phone: (603) 883-3390 Fax: (603) 886-3300 E-mail: support@monarchinstrument.com Website: www.monarchinstrument.
Safeguards and Precautions 1. 2. 3. Read and follow all instructions in this manual carefully, and retain this manual for future reference. Do not use this instrument in any manner inconsistent with these operating instructions or under any conditions that exceed the environmental specifications stated. This instrument is not user serviceable. For technical assistance, contact the sales organization from which you purchased the product or Monarch Instrument directly.
The pulse signal on the connector marked “Output” provides a sharp leading edge for reliable and repeatable triggering of the connected device. This output is capable of driving a hundred feet of coax cable. Be sure to select the direction (0 to 5 Vdc or 5 to 0 Vdc) of this signal to provide the required polarity of the leading edge to properly trigger the connected equipment. BATTERY DISPOSAL Prior to disposing of the SPSR-IM, the user must remove the Nickel Metal Hydride batteries.
INTRODUCTION SPSR-115/230 Series - SPSR-IM with ROS-P The SPSR-IM Self Powered Sensor Interface Module is a self-contained, rechargeable battery powered device for developing a TTL compatible one pulse per revolution output for triggering external equipment such as vibration analyzers, spectrum analyzers, stroboscopes, data acquisition equipment, tachometers, balancers, waveform analyzers and magnetic tape recorders.
operate directly from external power any time that it is being supplied. Otherwise, it functions on internal battery power. The “Output Selection” switch determines the polarity of the leading edge of the TTL compatible output signal. In the NON-INVERTING position, the output signal on the BNC connector will be a negative going 5 to 0 Vdc pulse derived directly from the conditioned sensor output.
ROS-P Remote Optical Sensor Operating Envelope: Speed Range: Illumination Source: Operating Temp: Output Signal: On-Target Indicator: Material: Lens: Cable Length: Dimensions: FUNCTIONS AND OPERATION Up to 3 feet [0.9 m] and 45° from reflective target 1 to 250,000 RPM Visible red LED, 5 Vdc @ 30 mA 14° F to 158° F [-10° C to 70° C] 5 to 0 Vdc TTL compatible pulse Green LED on end cap 303 Stainless steel Acrylic plastic 8 feet [2.5 m] Standard Threaded Tube - 2.90” L x 0.625 “ diameter [M16 x 1.
