User Manual

Rev: 0.92 06/22/11

Protection

The data Logger comes with a rubber boot that can be installed to protect the USB

connector and provide some degree of bump an d splash protection. T he unit should

have the boot installed when traveling. T he button can be o perated when t he boot is

in place. The boot cannot be fitted when analog modules are attached. The unit

should not be immersed in liquid.

Track-It

Software

The Track-It

PC Software allows the data logger to be programmed, allows the data to be retrieved, displayed, saved to disk or

exported to Excel

. Data can also be displayed in real time (on devices using internal sensors). The software has both simple and

advanced modes for programming data lo ggers. Some of the features are:

• Delayed recordings, fixed duration recordings by time or number of samples, multiple record times, manual record by button

press, record on alarms.

• Sample rates from 2 seconds to 24 hours. Instantaneous, average, maximum or minimum values.

• Two Alarms, high or low, latched or momentary and record under these alarm conditions

• Input scaling and offset for analog modules. Engineering unit selection for internal sensors.

• Button function - record off/on, status indication, reset alarm indic ation.

• Display of data graphically, digitall y or tabular formats with alarm indic atio n.

• Export user selected data in Excel

or CSV formats. Filter data to be exported.

• Simple setup (single scree n) or advanced mode.

Replacing the Battery

To replace the batter y - loosen the two screws on th e back of the Logger and remove the bottom case half. Caution - the scre ws have

small plastic washers. There are two battery options. Replace the relevant battery then replace the cover and the screws.

Option 1 - Coin Cell CR2032 3 . 0V Option 2 - Lithium Thionyl Chloride EF651625 3.6V (LTC-7PN)