User Manual

Rev: 0.92 06/22/11

Analog Input:

Most Track-It

Data Loggers have the ability to measure up to 2 channels of analog inputs (4-20mA, 0-5Vdc etc) using external

analog modules that plug ont o the USB connector. These may be purchased from your dealer and ar e programmed using the Track-It

PC Software.

NOTE: Analog recordings ar e made via the USB connector. If possibl e (button programmed) STOP RE CORDING before plugging the

recorder into the PC so as not to record the USB signals, otherwise use the Track-It

Software "Stop Recording" button under the

Device Setup tab as soon as the device is plugg ed into the PC.

Protection:

The data Logger comes with a rubber boot that can be installed to

protect the USB connector and provide some degree of bump and

splash protection. The unit should have the boot installed when

traveling. The button can be oper ated when the boot is in place. The

boot cannot be fitted when analog modules are attached. The unit

should not be immersed in liquid.

Track-It

PC Software:

The Track-It

PC Software allows the Data Logger to be programmed, allows the data to be retrieved, displayed, saved to disk or

exported to Excel

. Data can also be displayed in real time (on devices using internal sensors). The software has both simple and

advanced modes for programming the Data Log ger. Some of the features are:

• Delayed recordings, fixed duration recordings by time or number of samples, multiple record times, manual record by button

press, record on alarms.

• Sample rates from 2 seconds to 24 hours. Instantaneous, average, maximum or minimum values.

• Two Alarms, high or low, latched or momentary and record under these alarm conditions

• Input scaling and offset for analog modules. Engineering unit selection for internal sensors.

• Button functions, LED functions and LCD display functions.

• Display of data graphically, digitall y or tabular formats with alarm indication.

• Export user selected data in Excel

or CSV formats. Filter data to be exported.

• Simple setup (single scree n) or advanced mode.

Replacing the Battery

To replace the batter y - loosen the two screws on th e back of the Logger and remove the bottom case half. Caution - the scre ws have

small plastic washers. There are two battery options. Replace the relevant battery then replace the cover and the screws.

Option 1 - Coin Cell CR2032 3 . 0V Option 2 - Lithium Thionyl Chloride EF651625 3.6V (LTC-7PN)