Printer User Manual

611 Font, bar code or density is invalid. The font, bar code
or density in the batch does not fit the format.
612 The data in this line of the batch is either missing or
does not match the format.
613 Reference point off tag.
614 Portion of field off tag. There may be an invalid
character in the packet. Make sure you did not enter O
for Ø.
615 Bar code width is greater than 16 inches or the number
of keywords for your PDF 417 bar code exceeds 928.
Decrease the density or shorten the amount of data to
print the bar code.
616 A bad dot falls on a bar code and the dot cannot be
shifted. A gray box is printed instead of the bar code.
However, 2D bar codes still print on the 9825/9850
printers when bad dots are present within the bar code
field.
618 Magnification must be 1 to 7 or 4 to 255 for the scalable
font.
619 The JIS (16-bit) code for Kanji is invalid.
620 Font and printhead dot density mismatch. A 300 dpi
font is specified in the format, but a 203 dpi printhead is
used in the printer or vice-versa. Check the font or
change the printhead to correct the error.
621 An error occurred opening the TrueType font file. Select
a different font to download. If the error message
persists, call Technical Support.
622 Not enough memory to create the downloaded TrueType
characters in the scalable (vector) fonts buffer.
Reconfigure the printer’s memory and increase the
scalable (vector) fonts buffer. Resend the font, format,
and batch packet after reconfiguring the memory. See
Diagnostics and Errors 8-19