Printer User Manual

765 The printhead has less than 8 bad dots (4 dots for
9403/9850 printers). The printer can shift bar code
fields to avoid bad dots. You may need to press
ESCAPE/CLEAR to continue printing. Print a test label
to confirm the number of bad dots.
768 Printhead has more than 30 bad dots (10 dots for
9403/9850 printers) or is not connected. Make sure the
printhead is connected.
770 The print motor is not ready. Call Technical Support.
771 The format specified by the application was not found.
Reload your application and format, and try again. If
the problem continues, call Technical Support.
790 Wait until the printer is idle (no batch waiting to print or
not receiving data) before you send any packets. This
error may occur when you try to print a test label if the
printer is busy.
791 The printer has an error pending. Turn off the printer.
Wait 15 seconds and turn it back on. Resend the
packets. If the problem continues, call Technical
Support.
792 The printer is not initialized. Call Technical Support.
793 The printer job queue is full. Turn off the printer. Wait
15 seconds and turn it back on. Resend the packets. If
the problem continues, call Technical Support.
850 Invalid script packet or not enough flash memory for the
script. The script download failed. Format flash
memory and download the script using the COPY
command from DOS or the ADK2 software.
851 Invalid lookup table or not enough flash memory for the
script. The lookup table download failed. Check the
data in the lookup table. Format flash memory and
download the script using the COPY command from
DOS or the ADK2 software.
8-22 Diagnostics and Errors