Printer User Manual

You can not change the supply position while the printer is
active. Changing the supply position will affect the print
position, dispense position, and backfeed distance. Once the
supply position is set, use the print control packet and
backfeed control packet to adjust printing and the dispense
position.
B6. cut_posn -300 to 300 in 1/203 inch. Use 0 for 9403/9825. Adjusts
where the tag is cut. The printer adjusts the cut position
according to the black marks on the supply. You may need to
adjust for aperture supplies. Increase to move the cut up,
decrease to move the cut down.
Example
{
I
,B,0,0,1,10,50
p
}
Indicates black mark and thermal direct stock has been loaded,
causes the printer to operate in on-demand mode, feeds the
supply approximately .05 inches up before printing the format on
each label (10/203 inches), and feeds the supply .25 inches
(50/203 inches) before cutting.
Defining the Print Control Packet
Use the print control packet (C) to set the contrast, print, and
margin adjustment, print speed, and printhead width.
Syntax
{
I
,C,contrast,print_adj,margin_adjust,
speed_adj,ph_width
p
}
C1. C Print Control Packet
C2. contrast -390 to 156. 0 is the default.
C3. print_adj -99 to 99 in 1/203 inch. 0 is the default. Adjusts where data
prints vertically on the supply. Increase the print position to
move print up, decrease to move print down.
C4. margin_adj -99 to 99 in 1/203 inch (or 1/300 inch for 9850 printer). 0 is
the default. Adjusts where data prints horizontally on the
supply. Increase the margin position to move print to the
right, decrease to move print to the left. Margin and print
position are format adjustments. They will not affect the
supply position, dispense position, or backfeed distance.
2-12
Configuring the Printer