Printer User Manual

Special Considerations When Using Backfeed
Make a note of the following items:
N
Be careful when tearing supplies, because the adhesive can
adhere to the printhead or platen roller.
N
Backfeed affects each label in the on-demand mode or the
first and last label of the batch in continuous mode.
N
When backfeed is enabled and multiple batches are sent, the
printer may not backfeed between each batch.
N
Backfeed should only be used when you need to advance
labels to the desired dispense point.
N
Backfeed does not interfere with the supply, print, or margin
positions you have set.
N
If the supply inter-label gap is not between .07 inch to .15 inch
(14 to 30 dots), you must adjust the dispense position and
backfeed distance accordingly.
See the following graphic for a representation of the following
adjustments: dispense position, backfeed distance, supply
position, print position, and margin position.
Contact Technical Support if you have problems adjusting where
the format prints on the supply.
2-20
Configuring the Printer