Specifications

Freewheel sprocket

When replacing the freewheel sprocket remove frame

covers if necessary. Dismantle the chain as described

in part ”Chain 1/2” x 1/8” ”.

Loosen the axle nuts and lift off the ﬂywheel. Remove

the axle nut, washer, chain adjuster and spacer on the

freewheel side. Place the special remover (Art. No:

9100-14) in the adapter and place the spacer and axle

nut outside. See ﬁg: Special remover. Replace sprocket-

adapter and assemble the new parts in reverse order

according to the above.

NOTE: Do not tighten the axle nut completely. It

must be possible to loosen the adapter-sprocket half

a turn.

The sprocket should be lubricated with a few drops

of oil once a year. Tilt the cycle somewhat to make

it easier for the oil to reach the ball bearing. See ﬁg:

Lubrication.

Fig: Special remover

(Art. No: 9100-14)

Fig: Lubrication

Fig: Hub assembly

Monark 881 E